Auto Anchor 730 Kit Tough waterproof remote control with LCD for marine equipment with chain counter: * Windlasses * Thrusters * Lights * Anchorwash * Davits * Passerelles * Kit includes one handheld console unit with cradle, one base station, a deck socket with 2m lead, a socket sealing cap, one sensor, 2 magnets, screws for the cradle and socket, installation and operation instructions. Features - 4 metres spiral cable Electrical protection against back-emf Rubber over-moulding for shock protection and grip Stowage on cradle Operation in parallel with all AutoAnchor products eg toggle switches, foot switches or other control equipment Connect to DC, AC and hydraulic systems Rugged cable and connectors with: Moulded plug and socket rated to IP67 2m flying lead from socket for better connectivity Gold plated contacts on plug and socket to reduce corrosion Socket sealing cap Present the length of rode to deploy Plus Windlass Control with Chain Counter Counts rope/chain or all-chain rode AA703 Base StationChoice of feet, metres or fathoms measurement Logs windlass operating hours for maintenance Easy calibration Electronic diagnostics for troubleshooting installation Auto stop and docking alarm when the anchor is close to docking Two speed operation Technical Specifications - Current Consumption: 50mA Power Supply: 12/24V DC Temperature Range: 23°F to 140°F (-5°C to 60°C) Output Maximum Current Draw: 12V DC: 3.5A 24V DC: 3.5A Output Minimum Current Draw: 12V DC: 10mA 24V DC: 20mA When connecting to solid stage switching or other low current windlass drive, a PLC or AC variable frequency drive, a dummy resistor load may be required. IP Rating: IP67 Outputs: 6 Rode – Chain Only: Stainless or galvanised steel Rode – Rope and Chain: Must have a minimum of 10ft (3m) of chain. Chain must be galvanised steel. Rope should be a good quality nylon anchor rope. Type 66 or equivalent EMC/Protection/CE: EN60945 For DC windlasses a dual direction solenoid is required.